by AlexandruM » Mon Aug 20, 2012 2:12 pm
Pictoras, multumesc de raspuns, am gasit corespodentele la diametru dar nu reuseam sa gasesc si marimea pasului.
Astfel:
5/16 x 14 - 8 mm cu pas de 14
5/16 x 18 - 8 mm cu pas de 18
3/8 x 10 - 10 mm
Asa e corect?
Gasit pe AZ:
The number 5/16 is the diameter of the pin, easily measured with a ruler. The 14 and 18 are the threads per inch, again easily measured. Obviously there are not an inch of threads exposed, so measure 1/2 inch and count the threads and multiply by two.
Pasul de 14, spre exemplu, reprezinta 14 fileturi pe 2.54 cm, care ar fi corespondentul in sistemul metric? Cu alte cuvinte daca ma duc la magazin sa cer un surub cu asa filet, ce cer de fapt?
Iulian, mai greu sa ma car cu tacul prin oras.
It's not the arrow, it's the Indian.
Player: Mezz ZZ38 + Ignite shaft
Break: Mezz Kai DI 2
Jump: Jacoby JHB-JCEXTB
Case: Dybior Classic Speed 2x4
Accesories: Extension & glove, Mezz tip tool, Q-claw